Последние обновлённые инструменты в Android Market

Taiwan Gamma Detector (v. 0.5.130073)

kakahow опубликовал приложение 2011-10-06
(обновлено 2013-08-16)

The environmental gamma radiation detection provided by Atomic Energy Council of Taiwan. Pray for Japan, God bless our Earth.

Please make sure you have installed Adobe Flash player before using Gamma Detector. If you haven't installed it, find it from Android market and install it.

Note:
This is NOT a official app provided by Atomic Energy Council of Taiwan.
However, data and websites are provided by Atomic Energy Council of Taiwan.

SquareCalc (v. 1.4)

Ladderwalker опубликовал приложение 2010-12-04
(обновлено 2013-08-16)

Enter the width and the height and it gives you the diagonal. Perfect for construction workers. Foot box in pro version.

Mobilscan - your OBD tool (v. 2.1.2)

Care2Wear A/S опубликовал приложение 2011-10-06
(обновлено 2013-08-15)

NB: Requires a MobilScan OBD adapter - get it from www.mobilscan.dk. It will not work with other adapters.

We have apparently not been sufficient clear about supported cars:
As this is an OBD adapter, only EOBD/OBDII compatible cars are supported.
In EU, all cars sold since 2001(gasoline)/2004(diesel) are required to be EOBD/OBDII compatible.
As far as we can tell, most brands comply, but if you have a French car, you may want to check its compatibility.
You may have luck with older cars, too.

Read more at www.mobilscan.dk!

*** New in version 2.0 *** :
* User interface revised.
* Improved use of tablets' larger display.
* Data recording - a sensor value that's currently shown is also logged. The collected data is available in the Snapshot Report in graphical and/or tabular format.
* New derived value: Energy burn. Works for diesel vehicles, too!
* Demo mode - built-in ECU simulator

Now you do not need to drive on with the MIL light on.
Now you do not need to wait to go to the garage with your car to know what is wrong.
Now you can prepare the garage by knowing what is wrong.
Now you can see what is wrong with your car on your holiday so that you know if you can drive on.

And all this for less than what most garages take for doing the same test once.

The system comprises an this app and an OBD Bluetooth adapter you either buy at the local dealer or online.

MobilScan gives access to car information as defined by the ISO standards about OBD, this means that you can read out fault codes, continuously receive and display a full list of engine parameters like oxygen sensor readings, air mass, temperature sensors and other parameters used by the engine control computer (ECU).
When you want to capture the current state of the car, you may send a 'snapshot report'. MobilScan compiles information about the current state of the car, and allows you to send this as a HTML report to a receiver of your choice (e-mail, Bluetooth, ...)

NB! The MobilScan software is free, but we're trying to make a living from this, and you'll have to buy the corresponding MobilScan OBD adapter from us. Please contact sales@mobilscan.dk for pricing and availability in your region. If you are already a MobilScan customer, you may use your existing OBD adapter.

If you are just looking for a fault code lookup tool, try http://market.android.com/details?id=com.care2wear.dtclookup_full


Credit:
Version 2.0 uses the ActionBarSherlock framework to implement action bar support on early Android versions. If you're a developer: try it!



keywords: mobilscan1obd1tool

HL UPnP Explorer (v. 3.05.03.20)

Debbie опубликовал приложение 2011-10-06
(обновлено 2013-08-15)

This is a media browser for UPnP and DLNA media servers. It can manage all the medias from the servers(including WMP, ps3, xBox, an so on), and let you select proper viewers to view them. You can also install the 'HL Media Share' as the UPnP server to share your medias.

ClockLiveWallpaper (v. 1.3.1)

kt0319 опубликовал приложение 2011-10-06
(обновлено 2013-08-15)

• Text color, font size corresponds
Watch as the text color to be displayed on the desktop, you can specify the font size.

• Time format flexibility
Day / month / year
month / day / year
Supports the display of various forms, such as.

• Display detailed responses where
Can be positioned freely in units of one pixel.
Can also be displayed between the icons and wallpaper for the course.

· Background
It is possible to display any image in the background. The background color can be specified

Nanny (v. 2.3.36)

r-booz опубликовал приложение 2010-12-04
(обновлено 2013-08-15)

Wireless nanny analogue ( baby monitor ) in your phone!

This application is one of the best in its category. The main features of this application are high stability, saving power battery usage and there are also a number of unique functions.

Please, read the help before using.

Specifics (in brief):
-"Call me back" function;
-Two way talkback;
-Sensibility level tuning;
-SMS about low battery;
-SMS about missed calls;
-SD card installation.

Specifics (in detail):
    General:
    To activate Nanny, use the “begin” item of the menu. Next you should input or choose among the existent contacts, a phone number on which Nanny will call in case of necessity. After this you can launch Nanny with the help of the special button on the screen.
    First ten seconds after launch Nanny is inactive. You can use this time to put quietly your phone on the chosen place. The advisable distance between child and phone is up to two meters. After having put the phone, make also sure that the microphone of your phone is not covered. We recommend putting the phone in the way its microphone will be directed in the child side.
    You have got the possibility to contact Nanny at any moment. All you have to do is to dial from the phone number that you indicated at the launch. Nanny will call you back during 30 seconds.

    Sensibility level:
    You have the possibility to tune the sensibility level of Nanny. The default value can be applied for the most part of devices still there are some requiring the adjustment of this parameter.
        
    Two way talkback:
     You can speak to your child with the help of the loud-speaker. It can be useful as parents’ voice usually calms down the child.

    SMS about low battery:
    Nanny will inform you (by using SMS) about low battery.
    
    SMS about missed calls:
    Nanny will inform you (by using SMS) about missed calls.

P.S. Thanks for any response.

Simple Kitchen Timer (v. 1.41)

Dev.suica опубликовал приложение 2010-12-04
(обновлено 2013-08-15)

Commercial kitchen timer feature was reproduced as simple as possible.
Set the timer for 99 hours 59 minutes 59 seconds to one second, it can tell you by the sound and vibration.

Complexes (v. 2)

CocoNuts опубликовал приложение 2010-12-04
(обновлено 2013-08-15)

Cette application vous permet d’additionner, soustraire, multiplier et diviser facilement des complexes.

Veuillez cliquer sur la pub pour soutenir cette application, merci

Remote Launcher Free (v. 0.3.5)

owtroid опубликовал приложение 2011-10-06
(обновлено 2013-08-15)

*** An excellent app -  Editor's Choice from DroidAppOfTheDay.com ***

Remote Launcher is an easy to use tool that enables you to launch applications remotely on your PC via your Android device with a single click. It can also be used to start your PC up, even if it is turned off, with the built in support for Wake On Lan. It consists of an Android app and a small server program for your PC.

There is also support for Android shortcuts and widgets (size 1x1) available to start programs even quicker.

You can configure Remote Launcher to start any application on your PC, e.g. start your mediacenter (xbmc etc), shutdown/restart the computer or run a custom script.

To use Remote Launcher you need to install the Remote Launcher Server on your PC. Downloads, installation instructions, user guides and examples are available on the project wiki:
http://remotelauncher.owtroid.com

The Remote Launcher server is written in Java so it should work on any pc with the Java Runtime Enviromnment installed (version 1.6 or later), be it Linux, Windows or Mac OS. It has been tested on Ubuntu and Windows 7.

Remote Launcher is a nice alternative to more complex remote control solutions such as vnc or ssh when you just need to start specific programs.

It's also possible to automate Remote Launcher using Android intents or shortcuts. That makes it possible to use it together with tools such as Tasker or Llama to perform tasks at certain events, e.g. "shutdown computer when I leave home" or "send wake on lan packet to computer and start xbmc when I get back home". The imagination is the limit.

Remote Launcher works both with wifi and cellular connections. However, if you use cellular and the pc running Remote Launcher Server is behind a router, you will have to configure port forwarding on your router to forward the port 4444 to your pc. You will also need to configure the Remote Launcher app to use the IP address of the router instead of the pc in this case.

If you run into any issues, please contact the developer as it is not possible to answer to comments in the Market. You can also follow us on twitter: http://twitter.com/owtroid

This is the free version. It is currently limited to having just one single server configured.  A paid version without limitations is also available: http://market.android.com/details?id=com.owtroid.remotelauncher

Mini Screen Torch (v. 1.1)

Oscar GM опубликовал приложение 2011-10-06
(обновлено 2013-08-15)

Light to you with your mobile screen with this small aplication (smalest than i could generate).