Популярные бесплатные инструменты в Android Market

Volumes (v. 1.2.3)

Inkling Software опубликовал приложение 2011-10-06
(обновлено 2011-10-06)

Your Android phone has up to seven different volume controls, and 'Volumes' makes it easy to control all of these from one convenient location. You can adjust each of the different volumes individually, or use the buttons to turn them all on or off with just one click.

Mobilscan - your OBD tool (v. 2.1.2)

Care2Wear A/S опубликовал приложение 2011-10-06
(обновлено 2013-08-15)

NB: Requires a MobilScan OBD adapter - get it from www.mobilscan.dk. It will not work with other adapters.

We have apparently not been sufficient clear about supported cars:
As this is an OBD adapter, only EOBD/OBDII compatible cars are supported.
In EU, all cars sold since 2001(gasoline)/2004(diesel) are required to be EOBD/OBDII compatible.
As far as we can tell, most brands comply, but if you have a French car, you may want to check its compatibility.
You may have luck with older cars, too.

Read more at www.mobilscan.dk!

*** New in version 2.0 *** :
* User interface revised.
* Improved use of tablets' larger display.
* Data recording - a sensor value that's currently shown is also logged. The collected data is available in the Snapshot Report in graphical and/or tabular format.
* New derived value: Energy burn. Works for diesel vehicles, too!
* Demo mode - built-in ECU simulator

Now you do not need to drive on with the MIL light on.
Now you do not need to wait to go to the garage with your car to know what is wrong.
Now you can prepare the garage by knowing what is wrong.
Now you can see what is wrong with your car on your holiday so that you know if you can drive on.

And all this for less than what most garages take for doing the same test once.

The system comprises an this app and an OBD Bluetooth adapter you either buy at the local dealer or online.

MobilScan gives access to car information as defined by the ISO standards about OBD, this means that you can read out fault codes, continuously receive and display a full list of engine parameters like oxygen sensor readings, air mass, temperature sensors and other parameters used by the engine control computer (ECU).
When you want to capture the current state of the car, you may send a 'snapshot report'. MobilScan compiles information about the current state of the car, and allows you to send this as a HTML report to a receiver of your choice (e-mail, Bluetooth, ...)

NB! The MobilScan software is free, but we're trying to make a living from this, and you'll have to buy the corresponding MobilScan OBD adapter from us. Please contact sales@mobilscan.dk for pricing and availability in your region. If you are already a MobilScan customer, you may use your existing OBD adapter.

If you are just looking for a fault code lookup tool, try http://market.android.com/details?id=com.care2wear.dtclookup_full


Credit:
Version 2.0 uses the ActionBarSherlock framework to implement action bar support on early Android versions. If you're a developer: try it!



keywords: mobilscan1obd1tool

ClockLiveWallpaper (v. 1.3.1)

kt0319 опубликовал приложение 2011-10-06
(обновлено 2013-08-15)

• Text color, font size corresponds
Watch as the text color to be displayed on the desktop, you can specify the font size.

• Time format flexibility
Day / month / year
month / day / year
Supports the display of various forms, such as.

• Display detailed responses where
Can be positioned freely in units of one pixel.
Can also be displayed between the icons and wallpaper for the course.

· Background
It is possible to display any image in the background. The background color can be specified

Remote Launcher Free (v. 0.3.5)

owtroid опубликовал приложение 2011-10-06
(обновлено 2013-08-15)

*** An excellent app -  Editor's Choice from DroidAppOfTheDay.com ***

Remote Launcher is an easy to use tool that enables you to launch applications remotely on your PC via your Android device with a single click. It can also be used to start your PC up, even if it is turned off, with the built in support for Wake On Lan. It consists of an Android app and a small server program for your PC.

There is also support for Android shortcuts and widgets (size 1x1) available to start programs even quicker.

You can configure Remote Launcher to start any application on your PC, e.g. start your mediacenter (xbmc etc), shutdown/restart the computer or run a custom script.

To use Remote Launcher you need to install the Remote Launcher Server on your PC. Downloads, installation instructions, user guides and examples are available on the project wiki:
http://remotelauncher.owtroid.com

The Remote Launcher server is written in Java so it should work on any pc with the Java Runtime Enviromnment installed (version 1.6 or later), be it Linux, Windows or Mac OS. It has been tested on Ubuntu and Windows 7.

Remote Launcher is a nice alternative to more complex remote control solutions such as vnc or ssh when you just need to start specific programs.

It's also possible to automate Remote Launcher using Android intents or shortcuts. That makes it possible to use it together with tools such as Tasker or Llama to perform tasks at certain events, e.g. "shutdown computer when I leave home" or "send wake on lan packet to computer and start xbmc when I get back home". The imagination is the limit.

Remote Launcher works both with wifi and cellular connections. However, if you use cellular and the pc running Remote Launcher Server is behind a router, you will have to configure port forwarding on your router to forward the port 4444 to your pc. You will also need to configure the Remote Launcher app to use the IP address of the router instead of the pc in this case.

If you run into any issues, please contact the developer as it is not possible to answer to comments in the Market. You can also follow us on twitter: http://twitter.com/owtroid

This is the free version. It is currently limited to having just one single server configured.  A paid version without limitations is also available: http://market.android.com/details?id=com.owtroid.remotelauncher

Bluetooth Auto Off (v. 1.3.5)

Mihai Stanciu опубликовал приложение 2011-10-04
(обновлено 2013-08-12)

Automatically turns off Bluetooth when a device disconnects.
This application saves your battery life. If you forget to turn off the Bluetooth, it will do it for you.

Main screen
- Enable Bluetooth control: enables the application to turn off the Bluetooth adapter
- Bluetooth: manually turns On or Off Bluetooth adapter
- Device connection status: displays list of configured devices and their status (connected or not)

Preferences
- Devices:  list of devices that can disconnect Bluetooth
- Timeout: delay time (seconds) before disconnecting Bluetooth. If a device reconnects Bluetooth will not be turned off.
- Vibrate on disconnect: vibrate when application turns off the Bluetooth
- Turn off when idle: turns off Bluetooth when no activity is detected
- Idle time: time to wait since last activity was detected

Delayed Lock TRIAL (v. 2.8.8 Tria)

j4velin опубликовал приложение 2011-10-04
(обновлено 2013-08-12)

Not using any pattern-, PIN- or password-lock is a huge security problem, but reentering your PIN code a hundred times a day can also be annoying.
'Delayed Lock' is a solution to this problem: After unlocking your device, it will turn the lock screen off for a user defined amount of time. You can turn your phone off and on as often as you want without entering your password/PIN/pattern again. After a certain time, it will automatically reactivate your lockscreen, so no stranger can unlock your device and access your private data.
Additionally, there is also an optional notification in the Android status bar and a widget to immediately reenable the lock screen, and free plugins to automatically keep the device unlocked while connected to a specific WiFi network / Bluetooth device or at certain locations.


DOES NOT WORK IF EXCHANGE POLICY REQUIRES A PIN!


Android 4.0/4.1:
Since ICS you need a rooted device to get the pattern lock & FaceUnlock working with the app! No root is required when using PIN or password lockscreen.


I can't respond to comments here, so if you have any problem and want them to be get resolved: Write me an eMail!

---------------
Main Features:
- Delayes the requirement to enter pattern/PIN/password again after succesfully unlocked once
- Delay since 'Screen off' or since 'Last unlock'
- Quickly re-enable the lock through the Android notification bar or a widget
- Widgets & Shortcuts: Toggle Lock, Screen off, Screen off & Lock, Start Simple Lock*, Enable / Disable DelayedLock
- Upgradable with free plugins: Unlock with WiFi, Bluetooth or location based and remote activate lockscreen via SMS
- compatible with HTC Sense & WidgetLocker, should also work with Tasker & Locale (see Support-Thread)
- music controls on simple lockscreen* (works with Spotify, Winamp, Google Music and more)

---------------
Important:
- Revoke admin permission to be able to uninstall!
- FAQ at http://forum.xda-developers.com/showthread.php?t=955092
- Remove exchange PIN on a rooted device: http://forum.xda-developers.com/showthread.php?t=655649 & http://forum.xda-developers.com/showthread.php?t=1367254
- Incompatible with NoLED, No Lock & some other apps -> test the trial version before!
- Incompatible on Android 4.0+ with full device encryption enabled

---------------
Legal information: I do not guarantee that your device's data is unaccessible and will not be responsible for any damage you or your company may get because of an unlocked device. Please check if the usage of the app is compatible with the security policy of your company.

---------------
* simple lockscreen is only available when using the 'hide lock' on Android 2.x

---------------
Permissions:
WRITE_EXTERNAL_STORAGE - needed to save images for simple lockscreen background / widget icons
DISABLE_KEYGUARD - needed when using the "hide lockscreen" method
WRITE_SETTINGS - needed to change display timeout on simpleLockscreen
WRITE_SECURE_SETTINGS - needed to disable pattern lock & USB debugging on rooted devices
VIBRATE - needed for "vibrate when locking" feature

battery percentage (v. 1.4)

vhsoft опубликовал приложение 2011-10-04
(обновлено 2013-08-12)

This app inserts battery percentage as an icon in the status bar.

-color per each range of percenatages.
-restores on boot.
-exit by click (moves the icon from status bar).
-doesn't waste battery.
-includes temperature.

Panda Memo (v. 1.4.0)

Pink Panda опубликовал приложение 2011-10-04
(обновлено 2011-10-04)

Panda memo is Easy.
There are no difficult settings. Anyone can use.
Is saved automatically, so it's supposed to disappear is not written.
• To create a new memo, please click the new note.
• The background is cute panda.
• Do not see your notes, edit them, please tap the list.
• To delete a note, long tap the list, please choose Delete.
• Note: To edit the title, long tap the list, please edit the title to choose.
• To search, type the characters displayed in the screen list, please click Search.
• It auto-save file changes are saved automatically.

Fast Uninstaller for Root (v. 1.9)

For2w опубликовал приложение 2011-10-04
(обновлено 2011-10-04)

Fast Uninstaller for Root is a fast, advanced, powerful, and easy to use replacement for slow,and user unfriendly System Uninstaller, it comes with functions like Uninstall by 1-click, search application in your devices,launch application,search you application Android Market. Fast uninstaller provides a total solution for the uninstalling task.

Requirement:
Root  devices


Features:
1) Uninstall and Launche applications easily by 1-click!
2) Show application name,verion,size,min SDK,icon
3) Search your application by keywords
4) User can open Application before uninstall.
5) all kinds of sorting
6) Simplest User Interface
7) Search your installed application in Android Market

keys:
Uninstall App,Uninstall Applications,Uninstall Games,Uninstall Apps,Open Apps,Open Applications,open games，fast uninstall,remover,cleaner uninstall app uninstaller remove app clean system remover quick uninsatller easy uninstaller app kill app killer
bloat freezer, deleteing, black list, manager root stock app system app pre-build app factory app sysapp uninstall SystemApp Remover app uninstall uninstaller app uninstaller app remove cleaner system app remover quick uninsatller easy uninstaller app manager app list batch remover app kill app killer uninstall uinstaller uninstall remove cleaner quick uninstaller uninstall uninstaller app manager app list batch uninstall uninstall uninstaller app manager uninstaller remove app delete app app delete app killer appkiller app cleaner, black list, write list

Repeater (v. 13.07.06)

ZBM2 Software опубликовал приложение 2011-10-04
(обновлено 2013-08-11)

Easily find Amateur (Ham) Radio Repeaters across the UK, Europe, Australia, Argentina, Brazil, South Africa, New Zealand and many more with the World's Free Repeater App!

** FOR OUR FRIENDS IN THE USA SEE OUR REPEATERBOOK APP **

• Complete database of UK Analog, IRLP, Echolink and D-Star repeaters.
• Growing database of over 30 countries.
• Supports BlueCAT - Touch a repeater to instantly set your radio!
• Use network, GPS or a Locator to find Repeaters.
• No network connection required.
• Displays your locator and selection distance.
• Comprehensive selection, sorting and display options.
• Displays distance, heading and full repeater details.
• Fast and flexible, designed to help Amateur (Ham) radio operators use the Repeater network.

** FOR OUR FRIENDS IN THE USA SEE OUR REPEATERBOOK APP **

Repeater and RepeaterBook will always be free.

If you like Repeater please review it, if not please email us before leaving a review, as there is no way for us to reply. Thanks!

Please contact us if you have data for your country that you would like added.

Thanks!

Nicolas